Back to Shop

Free Shipping HC-06 Slave Wireless Bluetooth Transeiver RF Module headphones diy diykit


The Bluetooth Modem is the latest Bluetooth wireless serial cable! This version of the popular Bluetooth uses the HC-06 module. These modems work as a serial (RX/TX) pipe. Any serial stream from 9600 to 115200bps can be passed seamlessly from your computer to your target.
Note:It’s HC-06 Bluetooth module
Allows your device to both send or receive the TTL data via Bluetooth technology without connecting a serial cable to your computer,Compatible with Arduino ,Raspberry Pi System etc.
 1.Works with any USB Bluetooth adapters.
 2.Default Baud Rate: 9600,8,1,n.
 3.Built in antenna.
 4.Coverage up to 30ft.
 5.Bluetooth version: V2.0+EDR
 6.Operating voltage: 3.3V
 7.Default Baud Rate: 9600,8,1,n.
 8.Signal coverage: 30ft
 9.Cable length: 21.5cm
 10.Item size: 4.3 * 1.6 * 0.7cm
Commercial Series: Bluetooth module board Series
 1.With LED indicator light, use 150mA and 3.3V regulation chip.
 2.With VCC,GND,TXD,RXD foot for the Bluetooth
 3.Compatible with bluetooth master module",slave module"or master-slave(whole) module.
Input voltage: 3.3~6V
 4.input power supply 3.3~6V, Prohibit more than 7V
No "Automatically prevent power supply peversing func", so please correctly connect power supply
We advise to install "Bluetooth master module"
The "State" is output foot for LED status, when bluetooth "Unconnected", output "Pulse" ; when bluetooth 
"connected", output "High level", we can determine the states from "MCU".
1x HC-06 Bluetooth Module.


There are no reviews yet.

Be the first to review “Free Shipping HC-06 Slave Wireless Bluetooth Transeiver RF Module headphones diy diykit”

Your email address will not be published. Required fields are marked *